Showing posts with label Kinetic Sculpture. Show all posts
Showing posts with label Kinetic Sculpture. Show all posts

Monday, September 22, 2008

Goldfish bowl

A few posts back I posted a bit of writing about a vision - if you will - that I had while meditating (yeah, I'm one of those guys). That sitting was inspiration for me to create a kinetic sculpture. Here are some early sketches of my idea:



The idea is to create a sculpture that in a way is like a giant Weeble or Bozo Clown Bopper (in principle, at least - Weebles wobble but the don't fall down). A goldfish bowl will sit on top of a rounded, bottom-heavy stand. To one side, a motor will raise and drop a hammer (probably made out of rubber; if not, out of some other soft material), which will fall to hit the side of the bowl, causing the whole sculpture to wobble about. Somewhere in the piece I hope to have a light, normally turned ON, connected to a tilt switch, that will flicker ON and off when the sculpture is moving (a tilt switch is an electronic component with moving parts inside that will complete and break circuits depending on the orientation of the switch). I am not sure yet whether or not I want the lamp to be hanging above the bowl or to be illuminating the water from below. The hammer will hit the bowl most likely 1 or 2 times every minute (maybe even less, like once every two minutes - it will all depend on the wobble). The whole sculpture will be plugged into the wall to get its power.

This piece is about the difficulties I have in finding calm in my life. The goldfish bowl is an inspiration taken from the shark tank vision, a moment of almost total control over my peace of mind. The literal imbalance of the piece is the imbalance of my emotions and thoughts. The hammer will swing consistently but slowly, allowing the object to come to a rest and for the light to stop flickering before upsetting the balance once again.

Friday, May 16, 2008

Orbit Machine

Here is a much more refined prototype than the one I made before (come to think of it, I don't believe that the other prototype was ever really completed). Anyways, there are some problems with the chain drive and the (handmade) rollers, and I have barely even begun to really flush out what images are going to be on top of the rings (it will be a moving drawing or painting when I finally complete it).










Monday, February 18, 2008

Breathing Hill 1


So here are the parts that I will be using to create a "breathing hill". The first solenoid let's air in, the second let's it out. The piece of aluminum will be faced by a milling machine, then drilled and tapped to allow for some attachments to be screwed into it. I think I will be getting a larger inner tube, but for now, this is good enough for the purposes of creating a model. There are many more details that need to be worked out, but this is the basic bone structure.